NVENT THERMAL CM-2000+ Control Module for T2000 Heat Trace Controller

Control modules, used in the DigiTrace T2000 HTC each control, monitor and communicate alarms and data for a single heating circuit. As single point controllers, they offer a complete range of features as well as superior reliability. The ability to install the units in Class 1, Division 2 hazardous areas supports direct field installation if desired. The option to use either an external solid-state relay (SSR) or an external contactor to switch single phase or three wire, three phase loads up to 600 VAC, makes the CM 2000/CM 2000+ control modules the most versatile products on the market. The actual temperature, the load current and the temperature set point are immediately accessible to plant operators and maintenance staff. The display units are field selectable in °F or °C. The ability to utilize one or two temperature sensor (TS) inputs, allows the selection of one of nine control modes and programming of all temperature parameters. High and low temperature alarms are offered for both temperature sensor inputs.